World's Best Oils & Filters for 1990 Jeep Wagoneer

Component Description: Latches/locks/linkages:doors:latch.

Service Bulletin Summary: Redesigned liftgate latch. ( nhtsa item number - 39539 ).

Component Description: Structure:frame and members.

Service Bulletin Summary: Difficult to clean light colored "chalky" residue from plastic body components that are molded in black. ( nhtsa item number - 51942 ).

Component Description: Power train:automatic transmission:park/neutral start switch.

Service Bulletin Summary: Subject on customer satisfaction notification #733--brake pedal shift interlock. ( nhtsa item number - 600604 ).

Component Description: Equipment:electrical:radio/tape deck/cd etc. .

Service Bulletin Summary: Information on installation of radio transmitting equipment. ( nhtsa item number - 600862 ).

Component Description: Seats.

Service Bulletin Summary: Information on child seat tether anchors. ( nhtsa item number - 607963 ).

Component Description: Structure:body.

Service Bulletin Summary: Subject on the child seat tether anchors. ( nhtsa item number - 612160 ).

Component Description: Electrical system:wiring.

Service Bulletin Summary: This bulletin provides a revised wire splice procedure and related parts. ( nhtsa item number - 609995 ).

Component Description: Seats.

Service Bulletin Summary: Subject regarding child seat tether anchors. ( nhtsa item number - 610635 ).

Component Description: Seats.

Service Bulletin Summary: Subject regarding child seat tether anchors. ( nhtsa item number - 615688 ).

Component Description: Electrical system.

Service Bulletin Summary: Subject regarding wire splice repairs. ( nhtsa item number - 618049 ).

Affected Component: Vehicle speed control:cruise control.

Summary: Malfunction of fuel injection system throttle postition sensor could cause intermittent high engine idle speed immediately after starting engine. .

Conequence: High engine idle when car is first placed in gear couldresult in unexpected acceleration. .

Remedy: Replace throttle position sensors with sensors that would send correct signals to the fuel injection system. .

Notes: System: throttle position sensor. Vehicle description: multi-purpose vehicles equipped with 4. 0 l engine andautomatic transmission. .

Affected Component: Service brakes, hydraulic:foundation components:hoses, lines/piping, and fittings.

Summary: Improper insertion/crimping of the hose-to-end fittings of the high pressure hose on the anti-lock brake system can cause detachment of the hose from the abs system, and discharge of hydraulic fluid. .

Conequence: Detachment of the hose from the abs system causes theloss of the abs function and hydraulic brake assist, leaving only manual brakesand decreasing stopping ability, which could result in an accident. Discharge ofhydraulic fluid in the area of the hot exhaust system could result in an enginecompartment fire. .

Remedy: Replace the abs high pressure hose. .

Notes: System: anti-lock brake system; abs high pressure hose attachment to end unit. Vehicle description: multipurpose passenger vehicle. .

Affected Component: Service brakes, hydraulic:foundation components:hoses, lines/piping, and fittings.

Summary: There may be hydraulic fluid contamination from condensation formation that can plug the abs brake booster pump filter; stress corrosion of the master cylinder snap ring has been traced to chlorine leaking from the low pressure hydraulic hose which may cause it to break; front brake hose to tire interference which may cause failure of the brake hose. .

Conequence: Contamination of the hydraulic fluid can causemalfunctioning of the anti-lock brake system; low pressure hose leakage causesloss of brake fluid and also results in corrosion and failure of the mastercylinder snap ring, resulting complete brake failure; failure of the front brakehose due to hose to tire interference will cause failure of one half of thebrake system resulting in a longer stopping distance than expected. .

Remedy: Replace abs low pressure hose; rebuild master brake cylinder; inspect, service interference problems, and replace front brake hose as necessary. .

Notes: System: hydraulic fluid contamination; anti-lock brake system (abs). Vehicle description: multi-purpose vehicles equipped with anti-lock brakesystem. .

Affected Component: Service brakes, hydraulic:antilock/traction control/electronic limited slip.

Summary: Vehicle description: vehicles equipped with antilock brake system (abs). The antilock brake system (abs) hydraulic control unit can experience excessive brake actuator piston seal wear which could cause pump-motor deterioration. .

Conequence: If this occurs, the abs function would be lose and reduced power assist would be experienced during vehicle braking. The instrument panel warning lights will signal system impairment and the base manual brakes will remain functional. .

Remedy: Dealers will test the vehicle's abs and repair as necessary. The warranty on all abs components will be extended to 10 years or 100,000 miles (except for the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage). Owners will be reimbursed for previous abs component repair costs. .

Notes: Owner notification began april 24, 1997. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chrysler at 1-800-853-1403. Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393. .

Affected Component: Service brakes, hydraulic:foundation components:disc:rotor | service brakes, hydraulic:foundation components:disc:rotor.

Summary: Vehicle description: passenger and multi-purpose vehicles originally sold or currently registered in the states of connecticut, illinois, indiana, maine, maryland, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, or wisconsin, and the district of columbia. The front disc brake rotors can experience severe corrosion if operated for an extensive period in the "salt belt. " if the rotors are not replaced, the corrosion can eventually compromise the structural integrity of the stamped steel center hub section of the rotor. .

Conequence: The reduced strength can allow the cast iron wear surface to separate from the hub, reducing the brake effectiveness of the vehicle. .

Remedy: Dealers will replace these rotors with rotors that are coated with a corrosion protection. .

Notes: Owner notification began march 9, 1998. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chrysler at 1-800-992-1997. Also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236). .