Engine, with filter » 4.7 liters
[1] Cooling System, With AC Initial Fill » 6.5 liters
Passenger Car & Light Truck Antifreeze & Coolant AMSOIL Antifreeze and Engine Coolant Cooling System, Without AC Initial Fill » 6 liters
Passenger Car & Light
Truck Antifreeze & Coolant AMSOIL Antifreeze and Engine Coolant Automatic Transmission, A4LD Initial Fill » 2.8 liters
Automatic Transmission, Total Fill
4 speed RWD A4LD » 8.5 liters
4 speed 4WD A4LD » 9.5 liters
Manual Transmission, 4-SPD » 1.4 liters
Manual Transmission, Mazda (5-SPD) » 2.8 liters
[2] Manual Transmission, Mit (5-SPD) » 2.3 liters
Differential, Dana 28 Front » 0.5 liters
[3] Differential, Dana 35 Front » 1.7 liters
Differential, Rear » 2.4 liters
[4] Transfer Case, U/K TRC » 1.4 liters
ANTPC ANT ANTPC ANT
Capacities Comments [1] When refilling, remove dipstick to provide adequate venting
and allow oil to flow into crankcase. After refill, check
oil level. Top off to proper level as needed.
[2] The drain plug on the Mazda transmission is at the rear of
the pan. Drain plug on the Mitsubishi transmission is at the
center of the pan.
[3] With Dana 28: If fill hole is at centerline of
axle must have lube level
no higher than 1/2 inch below fill hole. Models
with fill plug below centerline of axle must have
lube level no higher than 1/8 inch below fill hole.
[4] Fill to no more than 1/4 to 9/16 inch below fill plug hole.